#2015 f150 stereo upgrade kit full#

The Kicker amp for the door speakers actually allow a pretty much full volume music playing with very nice sound but would not mind the door speakers a little louder compared to the bass I just added. Vibrates the seat and rear mirror as well.

Now, I had the amp with a 10' sub in my Camry before the truck and the 10' in the trunk sounded deeper but the two 8' subs do play good with the tight bass and does play fairly low bass for the size. To me it sounds great considering the factory sound prior to the installation. I also added a remote bass volume control for the amp. Of course, with the seats down there is ALL kinds of room behind there. Locks into place without any more effort than before and allows complete use of the floor. Does not interfere with the seat stowing. It is a metal piece that protrudes out some. The last pic shows part of the seat pushing up against the box. Just above the sub is where the seat starts to get closer to the box so a bigger sub might have wedged up against it. View from down looking up with the seats up and stowed. I ran a single power wire from the battery to the rear and then made both (front amp and sub amp) at a single point. I also ran the under dash amp power to the rear instead of the engine compartment. Ran short on power wire but will be cleaning that up later.

There is a metal tube in the seat that would make contact. However, it is close and if the subs were any bigger then the hight of the sub from the floor would probably make contact with the seat rear. I have no touching of the subwoofer or surround with the seat with the seats up. This prevents it from moving forward but it was pretty secure anyways. I used an 'L' bracket that I put a rubber strip on and then fit it into a slot that was on the back wall and then screwed the bracket in the top sub box. The rear I just trimmed what I needed to trim to allow the box to fit. I removed the bottom carpet insulation backing but left the carpet. With the box installed, it fits great with the height and width with not having to relocate the motor for the rear window slide. Once the box was complete I added another front face panel so that the subs will have the 'recessed' look and to strengthen the front baffle panel. I know a few have 10' subs and other style boxes but I was (am still am) pretty close with the seat spacing when the seat is up. I chose these numbers based on the volume and depth of the speakers. I cut out the height on the side with the amp to accommodate the amp. The base is 5.5' but the actual enclose speaker box portion on the box is 23' width x 15' height x 2.75' top depth x 3.75 bottom depth. I made the notches to fit above the bolts on the floor and used some brackets with nuts to help secure the box once it was in.īuilt the box with the following dimensions. Again, I put it in the split tubing for protection and a more factory look.īuilt a box to fit behind the seat. I did break a couple of the small white clips but ordered some new ones before I re-installed.

#2015 f150 stereo upgrade kit driver#

Ran power and signal down the driver side door sill area.

I used some little brackets so I could tip-tie the cable for security. I put the power in split tubing for a better factory look. I ran the power from the battery to the driver side firewall grommet area with the bundle of wires. The bracket mounted up easily and is very stable. I had to modify the 2013-2014 Kicker bracket to allow it to mount under the 2015 dash. Only had to cut the rear carpet to allow placement of sub. I did not want to relocate the rear window motor or manipulate anything major on the truck. Custom box that fits behind the seat with 2 8' Kicker CompRT shallow mount subs.Ĥ. Used a Kicker 250.1 amp that I had already but might upgrade at a later date.ģ. Sold the speakers and under seat subwoofer since I wanted to retain full use of floor.Ģ. Harness matched perfect to my touchscreen with Navigation OEM unit. Kicker DSP multichannel amp from the 2013-2014 VSS kit from Rogel Ford. I know there are other thread and did not want to post this on those threads.